Konnra Electronics CO., LTD.

When we design and manufacture industrial machinery, or consumer equipment, we are faced with a choice, whether to use point-to-point cable "hard connection" to the system, or choose a plug-and-play connector. From a longer-term perspective, of course, the wiring based on connector products is more practical and lower in cost.  Konnra connector  engineers will investigate the reasons behind and introduce you to the fact that connectors are better than hard wiring. Where is it. 1. More time-saving and lower cost General industrial equipment contains a large number of wires between its components and subsystems. When the original equipment manufacturer manufactures the product, it will be assembled at the factory before shipment, then the system is disassembled, disconnected and shipped to the end user, where it is reassembled . If you need to hardwire all cables into the system, then remove and rewire them on site, this will be a very time-consuming task. The pre-assembled con...

There are a variety of problems encountered in the production of wire harnesses, not only from the product itself, but also from the process flow class. In the process flow, it will involve the problem of terminal machine failure. How can the wire harness manufacturer solve the terminal machine failure? The following  Konnra Electroncis  engineers will answer you when the terminal machine is faulty. What should I do? The first point: When the length of the cutting of the electronic wire is inconsistent, the possible reason is that the wire feeding wheel of the terminal machine is pressed too tightly or too loosely; the solution is to adjust the straightening device so as to be able to perform the straightening function and can be smoothly sent out. , the cutting edge is worn or the knife edge is replaced or a new cutter is replaced. Second point: When the length of the peeling opening is different, the wire feeding wheel may be pressed too tightly or loosely; use the roller...

The car wiring harness is also known as the "blood vessel" of the car. It is often referred to as the central nervous system of a car. The position of the car harness design in the whole vehicle is very important. Studying the quality control points of the automotive wiring harness manufacturing process is of great significance for improving the vehicle qualification rate and reliability. There are four main processes in the production of automotive wiring harnesses: stripping – crimping – pre-loading – assembly. The production process sets the corresponding standardized operation specifications for different production processes, so that the quality of the wire harness products produced can be effectively guaranteed. (Image from Internet) Stripping process Stripping refers to stripping the insulation on the wire according to the requirements of the work instruction, and the length should meet the requirements. Good stripping requires wire type, wire diameter, thread ...